1.Take out the air filter. Open up the small steel clip with hands to peer through 1 cm away from the edge line of the strong oxygen catalyzer(as illustrated).Two at each side. Then use the pointed end of the pointed pliers to pull open the small steel clip to clip to blade inside the filter net. 2.If the blade is too thin, the small steel clip may clip two filters at one time to make it fix better. 3.The catalyzer may be installed at the front and reverse sides of the filter. However, it is better to install at the clean side. 4.The size of the strong oxygen can be cut to same size as of the area of the air filter.
1. ВЫНЬТЕ ВОЗДУШНЫЙ ФИЛЬТР. ОТКРОЙТЕ UP THE SMALL STEEL CLIP WITH HANDS TO PEER THROUGH 1 CM AWAY FROM THE EDGE LINE OF THE STRONG OXYGEN CATALYZER (AS ILLUSTRATED).TWO В
1.Use a piece of clean cloth or tissue paper to wipe the front lateral side of the battery. If there is grease on the surface,use a cleaning naphtha or solvent to get rid of the dirt. 2.Tear off the
The installation Instruction for whole set of Photoelectric Booster Secondary element oil carburetor 1.Please find out the gasoline filter(cup) to get into the in-feed pipe of the engine.(Oil inlet p
The installation Instruction for whole set of Photoelectric Booster Secondary element oil carburetor 1.Please find out the gasoline filter(cup) to get into the in-feed pipe of the engine.(Oil inlet p
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during oper
помощь**
Добавить в избранное
Отложенные товары
