The installation Instruction for whole set of Photoelectric Booster Secondary element oil carburetor 1.Please find out the gasoline filter(cup) to get into the in-feed pipe of the engine.(Oil inlet pipe) 2.Cover the product on the oil pipe. Use pointed pliers to clip the oil carburetor onto the pipe with force. Make sure to clip tight, no moving or loosening is allowed. This product is composed of six blocks. The installation distance among each block shall be no more than 0.5cm. 3.Cautions:Do not install on the circulated oil pipe, or it is best to install on plastic oil pipe.
The installation Instruction for whole set of Photoelectric Booster Secondary element oil carburetor 1.Please find out the gasoline filter(cup) to get into the in-feed pipe of the engine.(Oil inlet p
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during oper
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during oper
1.Take out the air filter. Open up the small steel clip with hands to peer through 1 cm away from the edge line of the strong oxygen catalyzer(as illustrated).Two at each side. Then use the pointed e
1. ВЫНЬТЕ ВОЗДУШНЫЙ ФИЛЬТР. ОТКРОЙТЕ UP THE SMALL STEEL CLIP WITH HANDS TO PEER THROUGH 1 CM AWAY FROM THE EDGE LINE OF THE STRONG OXYGEN CATALYZER (AS ILLUSTRATED).TWO В
помощь**
Добавить в избранное
Отложенные товары
