Adresse : 4F, No.1-21,Kuo-Jian Rd., Chien-Chen District
Téléphone : +886-7-8152177
.
Electroplating is a process of electrolysis which provides the sheet metals of layer metal to function as anode. The electrolyte usually is ion solution plated with metal and the function of workpieces to be electroplated is similar to cathode. After voltage was conducted between anode and cathode, metal ions of electrolyte was attracted to swim to cathode and plated on it after reduction. Moreover, the metal of anode redissolves and provides more metal ion to electrolyte. Under some circumstances the insolubility is used. Flesh electrolyte is added to replenish plated metal ions. Pre-Surface-Treatment (water-soluble solution) A general process follows some steps as below ( prepared for degreasing or hot water rinsing) → Main degreasing → water rinsing (1) → water rinsing(2) → surface adjustment → chemical conversion (zinc phosphate) → water rinsing (3) → water rinsing (4) → or adding D.I. water to rinse again. If using ferric phosphate system, surface adjustment is then unnecessary. Degreasing is surfactant which consists of Alkali and emulsion. Emulsion is to emulsify oil and prevents from poor adhesion, and by means of alkali to set apart from greasy and keep clean. After rinsing the surface part we precede the chemical conversion in order to strengthen the adhesion, erosion resistance. For the purpose of saving this treatment process, we combine degreasing with chemical conversion into "Two-in-One"(or "Three-in-One") process. It turns out that non-alkali component of degreasing will remain only emulsion and phosphate. Disposing greasy must rely on the acid component which results from the chemical conversion. Therefore, the solution will be overused, and more important thing is, the quality of treatment can not control any stability. That leads to bad affect on coating.
Powder coating is a type of dry coating, which is applied as a free-flowing, dry powder. The main difference between a conventional liquid paint and a powder coating is that the powder coating does no
Thermolaquage est un type de revêtement sec, qui est appliqué comme un écoulement libre, de poudre sèche. La principale différence entre une peinture liquide assique et d`un revêtement en pou
Metal removal résiduelles par échangeur d`ions pour le respect des limites admises pour les métaux lourds à une puissance de 1-20 m / h. C`est un type spécial d`échangeur d`ions (cations Séle
Retard des plantes pour la régénération d`acides et bai e processus contenant contaminer et / ou des ions métalliques inquiétan , c`est à dire bai e l`oxydation anodique et le décapage se bai e
TCCF (tandem, en continu, le nettoyage, le système de filtre), un système continu, auto-nettoyage du filtre avec d`excellen résulta de filtration, ainsi que des hau responsables des médias de v
Installations de traitement des eaux usées de galvanoplastie boutiques, de la production chimique, la restauration de meubles, ainsi que l`émulsion de craquage plantes en fonction de l`état de la t
Composed of various complexing agents, corrosion inhibitors, brightness regulator, cleaning agents and surface active agent. It has the following advantages, while comparing with the traditional alkal
This product is in light green powdered solid form. Composed of Ni-F compounds, including F polymers, promoting agent, stabilizer, and infiltration of suppression gray, metal cobalt salt, dispersing a
Aide
Ajouter á l'élu
Les marchandises remises
