MM06 is Mifare serial number only proximity reader module. It is intended primarily for use in access control system applications. MM06 reads the Mifare card identification number and transmits it to the access control system using the common Wiegand 26 bit interface or any other OEM interface requirements in the futureSpecificationReads Mifare serial number onlyMeets ISO14443 TypeA standardSupported transponders: Mifare Ultralight 512-bit EEPROM/Mifare Classic 1K,4K,8K bytes memoryFull potting for outdoor use, waterproof/or without pottingSize 20mm *30 mmPower requirements 5V DC at 100 mAInterface Weigand26 for connection tostandard access control panelsReader range Min.6 cm and up to 10cm with standard Mifare 1 cardFrequency 13.56MhzOperation temperature -30 C to +60 COperationg humidity 5%-95% relative humidity non-condensingAudio/Visual Indication Green & Red and Buzzer signal outputLED function: The LED color is normally in RED. It starts with 3 green flashes on power up the reader and remains RED. When a RFID proximity card is present to the reader, The LED will momentary flash green, this indicates that the card was read properly by the reader. When the LED control signal is active, the LED changes to green. The LED control signal is provided by the panel to control the reader LED stateBeeper Function: Power up the reader, the beeper will active three times. When a RFID proximity card is present to the reader, a short beep will be emitter. This indicates that the card was read properly by the reader
M6100 is mifare serial number only proximity reader. It is intended primarily for use in access control system applications. M6100 reads the mifare card identification number and transmits it to the a
read HID and EM card at same time.WIegand26 output formatsamll size at 20*32*8mm+5 V DC input @50mAreading distance(with standard antenna), HID>5cm, EM>6cmthis module is shipped with antenna together
HM6600 is long distance TI ISO15693 tag reader/writer.Operating voltage:12VDCRFOutput power:1WSMA interface match with 50ohm RFID antennaResponse Distance:70cmHandle 30~50 PCs tag one timeWith support
We are making hid compatible card reader, it can read all standard hid card. This card reader with wiegand output interface, this reader is compatible with hid6005, small size. 5 wires output.Specific
We are making hid compatible card reader, it can read all standard hid card. This card reader with wiegand output interface, it read mifare and HID card together, small size. 5 wires output.Specificat
HM6601 is samll size, designed for TI 15693 tag(cards) reading/writing application.Detail as below:Operating voltage:5V/200mA(max)Frequency:13.56MHzAntenna: 50ohm (Ext)Interface:3-wire(COMS,TTL)Size:3
Function1. Night vision feature2. Motion detection3. All-weather camera4. Operate in auto, manual, scan mode5. Adjust cycle time6. Idle channel can be on / off7. Desktop or wall mounting8. Portable wi
Function1) . Built-in key pad and voice guide for friendly operation2) . Auto-dial up to 8 preset phone numbers once an intruder is detected3) . Listen and talk to the guy nearby the base receiver as
help
Add to favorite
Favorite products
