We are making hid compatible card reader, it can read all standard hid card. This card reader with wiegand output interface, this reader is compatible with hid6005, small size. 5 wires output.SpecificationDimension: 12x10x1. 5cmPower requirements 5-16v DC at 150 ma, a linear regulator is recommendedInterface weigand for connection tostandard access control panelsReader range 20 cmFrequency 122-128khzOperation temperature-30 c to + 60 cOperationg humidity 5% -95% relative humidity non-condensingAudio / visual indication green & red and buzzer signal outputResponse time less than 0. 2 secLED function: the LED color is normally in red. It starts with 3 green flashes on power up the reader and remains red. When a rfid proximity card is present to the reader, the LED will momentary flash green, this indicates that the card was read properly by the reader. When the LED control signal is active, the LED changes to green. The LED control signal is provided by the panel to control the reader LED stateBeeper function: power up the reader, the beeper will active three times. When a rfid proximity card is present to the reader, a short beep will be emitter. This indicates that the card was read properly by the reader
We are making hid compatible card reader, it can read all standard hid card. This card reader with wiegand output interface, it read mifare and HID card together, small size. 5 wires output.Specificat
HM6601 is samll size, designed for TI 15693 tag(cards) reading/writing application.Detail as below:Operating voltage:5V/200mA(max)Frequency:13.56MHzAntenna: 50ohm (Ext)Interface:3-wire(COMS,TTL)Size:3
Function1. Night vision feature2. Motion detection3. All-weather camera4. Operate in auto, manual, scan mode5. Adjust cycle time6. Idle channel can be on / off7. Desktop or wall mounting8. Portable wi
Function1) . Built-in key pad and voice guide for friendly operation2) . Auto-dial up to 8 preset phone numbers once an intruder is detected3) . Listen and talk to the guy nearby the base receiver as
HM6607 is a ISO15693 tag reader and writer. It works with tag such as PHILIPS I-code, TI Tag-it, and Pico etc.It works in middle range 30-40cm and also can work in long range (0.8-1meter), see detail
HM6033 EM+HID card reader, reads EM and HID card together, data is sent via Wiegand interfce, Wiegand 26 or 34 for EM.Input power can be 5-16VDCStandby current:30 mASupport cards: All standard HID car
PCB module can read all standard HID card, output interface is wiegand or RS232 TTL.small size : 20*30mmreading distance is : >6 cmworking voltage: +5Vcurrent: 20 mA
We are making hid compatible card reader, it can read all standard hid card. This card reader with wiegand26/34 output interface, this reader is compatible with hid6005, small size.5 wires output.Spec
Hm08-wr is hid compatible reader module with two kinds output format, they are wiegand and rs232. Once card is detected by module, data will be send out on the different output pin.SpecificationSize 2
help
Add to favorite
Favorite products
