Photoelectric Pressure Power Implement,pressure power
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during operation and cause danger. 2.Unscrew the nut of the positive charge connector on the battery, put the cable end of the photoelectric super conducting intothe screw,and tighten up the nut. 3.Then proceed with the same steps to lock the other end of the photoelectric super conducting onto the major power socket of the generator. Cautions: Afther photoelectric super conductor is installed. Please be sure to tie the cables with a plastic band to fix at a safe place. Do not fix (or contact with) at high heat objects,such as;metal tube,hot water pipe,and engine,or the high temperature will cause resistance to cable and melt it,which in turn will casuse short circuit and fire accident. Please bear this in mind. 4.Find a setscrew close to car body metal plated of the battery,tighten up the third cable (scratch off the metal plated paint a little)to get better current conducting result. Usually,all the cars are installed one or two original negative cables from generator to car body metal. 4-1 If you can not find a setscrew, drill a hole beside to the original negative cable 10~20cm and tighten up. 4-2 If you can not find a setscrew,drill a hole beside to the original negative cable 10-20cm and fasten with a screw. 4-3 If there is difficult for step 4-1 or 4-2,you can find out any set screw of car body metal. NOTE:Any setscrew can not be installed with two cables. the distance of each setscrew should be 30cm at least.
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during oper
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during oper
1.Before installing this product,please unscrew the negative charge connector on the battery and take down the breaker, then move under the battery and fix to avoid contacting the battery during oper
1.Take out the air filter. Open up the small steel clip with hands to peer through 1 cm away from the edge line of the strong oxygen catalyzer(as illustrated).Two at each side. Then use the pointed e
1.Take out the air filter. Open up the small steel clip with hands to peer through 1 cm away from the edge line of the strong oxygen catalyzer(as illustrated).Two at each side. Then use the pointed e
1.Use a piece of clean cloth or tissue paper to wipe the front lateral side of the battery. If there is grease on the surface,use a cleaning naphtha or solvent to get rid of the dirt. 2.Tear off the
1.Use a piece of clean cloth or tissue paper to wipe the front lateral side of the battery. If there is grease on the surface,use a cleaning naphtha or solvent to get rid of the dirt. 2.Tear off the
1.Use a piece of clean cloth or tissue paper to wipe the front lateral side of the battery. If there is grease on the surface,use a cleaning naphtha or solvent to get rid of the dirt. 2.Tear off the
The installation Instruction for whole set of Photoelectric Booster Secondary element oil carburetor 1.Please find out the gasoline filter(cup) to get into the in-feed pipe of the engine.(Oil inlet p
help
Add to favorite
Favorite products
