Address: NO. 11, LANE 30, LUNG CHUNG ST., LUNG TAN LI,
YUNG KANG CITY
Phone: +886-6-2323582
Aluminum Billet Saw
Introduction: 1.This equipment can put a lot of billets on the storage table and continuously cut billets. 2.This equipment uses PLC electricity automatic control and it is easy to operate. 3.Cooling cutting oil automatically supply and stop. 4.It can depend on the billet length and material to adjust the cutting length and speed. 5.Cutting diameter of Billet: φ3 ~φ8 ;φ3 ~φ10 6.Cutting one cycle time: φ3 ~φ6 about 12 seconds; φ7 ~φ10 about 30 seconds
Horizontal Single Movement Aluminum Extrusion Press There are different inches of press such as 3.5"(580US TON), 4"(690US TON),5"(930US TON), 5.5"(1100US TON), 6"(1450US TON), 7"(1800US TON), 8"(2200U
This equipment consists of Initial table, Roller Sleeve Raise/lower conveyer (Adjustable speed), Run Out transfer table (belt type), Cooling table (belt type), Stretcher, Stretcher Transfer table (bel
This equipment consists of Initial table, Roller Sleeve Raise/lower conveyer (Adjustable speed), Run Out transfer table (Flat Transfer Type), Cooling table (Flat Transfer Type), Stretcher, Stretcher T
The puller operates in coordination with 420 US Ton~4400 US TON extrusion press to produce various special industrial aluminum products. It is easy to operate and retrench manpower. This machine is ma
Introduction: 1.The method for cutting billets is cutting from up to down. 2.This equipment has the function of aluminum billet saw and operates in coordination with LPG direct fire billet heating fur
help
Add to favorite
Favorite products
