Address: 4F, No.1-21,Kuo-Jian Rd., Chien-Chen District
Phone: +886-7-8152177
Plating Equipment
Electroplating is a process of electrolysis which provides the sheet metals of layer metal to function as anode. The electrolyte usually is ion solution plated with metal and the function of workpieces to be electroplated is similar to cathode. After voltage was conducted between anode and cathode, metal ions of electrolyte was attracted to swim to cathode and plated on it after reduction. Moreover, the metal of anode redissolves and provides more metal ion to electrolyte. Under some circumstances the insolubility is used. Flesh electrolyte is added to replenish plated metal ions. Pre-Surface-Treatment (water-soluble solution) A general process follows some steps as below ( prepared for degreasing or hot water rinsing) → Main degreasing → water rinsing (1) → water rinsing(2) → surface adjustment → chemical conversion (zinc phosphate) → water rinsing (3) → water rinsing (4) → or adding D.I. water to rinse again. If using ferric phosphate system, surface adjustment is then unnecessary. Degreasing is surfactant which consists of Alkali and emulsion. Emulsion is to emulsify oil and prevents from poor adhesion, and by means of alkali to set apart from greasy and keep clean. After rinsing the surface part we precede the chemical conversion in order to strengthen the adhesion, erosion resistance. For the purpose of saving this treatment process, we combine degreasing with chemical conversion into “Two-in-One” (or “Three-in-One”) process. It turns out that non-alkali component of degreasing will remain only emulsion and phosphate. Disposing greasy must rely on the acid component which results from the chemical conversion. Therefore, the solution will be overused, and more important thing is, the quality of treatment can not control any stability. That leads to bad affect on coating.
Electroplating is a process of electrolysis which provides the sheet metals of layer metal to function as anode. The electrolyte usually is ion solution plated with metal and the function of workpie
Powder coating is a type of dry coating, which is applied as a free-flowing, dry powder. The main difference between a conventional liquid paint and a powder coating is that the powder coating does no
Powder coating is a type of dry coating, which is applied as a free-flowing, dry powder. The main difference between a conventional liquid paint and a powder coating is that the powder coating does no
Residual metal removal via ion exchanger for the observance of admissible limits for heavy metals at an output of 1-20 m /h.It`s a special kind of ion exchanger (selectiv cation) to remove heavy meta
Retardation plants for the regeneration of acids and process bathes containing contaminating and/or disturbing metal ions, i.e. anodic oxidation bathes and pickling bathes. Good handling, package-type
TCCF(tandem, continuous, cleaning, filter system), a continuous, self-cleaned filter system with excellent filtration results, as well as high-viscose media. It may be used ro remove solids from 3 - 3
Plants for the treatment of waste water from electroplating shops, of chemicals production, furniture restoration, as well as emulsion cracking plants according to the state of current technology.Melt
Composed of various complexing agents, corrosion inhibitors, brightness regulator, cleaning agents and surface active agent. It has the following advantages, while comparing with the traditional alkal
help
Add to favorite
Favorite products
